Winland

For simple low cost protection from freezing in homes, mountain cabins, or any unattended building, the Temp°Alert TA-40 will activate any hardwire or wireless alarm system if the temperature should fall below 39°F (4°C). The TA-40 offers positive protection and peace of mind to residential and business owners concerned about the risk of frost shattered pipes and the water damage that follows.

Winland offers three WaterBug® models for dependable water detection. Ideal for basement sump pumps, drain and storage areas, computer rooms, document storage areas, warehouses and sprinkler systems. WaterBug® sensors activate when a conductive bridge is formed between two contacts.

Use in conjunction with alarm panel, bell, wireless transmitter, etc. Connect as many as 6 sensor probes up to 100' (30.48 m) away from the console for wide area protection.

• Available in 12 and 24 volt models (EA200-12 and EA200-24)
• Simultaneous operation of both zones
• Defrost time delay up to 120 minutes
• Easy to read large LCD display
• Eight event alarm memory with time and date
• Auxiliary output relay for local audible alarm
• Auxiliary alarm silence feature with 10 minute timer
• Each zone has offset calibration adjustment
• Temperature and Humidity high/low set points
• Output relays can be configured to be initially energized or de-energized
• Tamper proof lock setting
• Snap fit mounting base with main housing for easy access
• Plug in terminal strip connectors for easier wire termination
• Zones being monitored are displayed every few seconds
• Display F°, C°, % (Humidity) or Water Drop icon
• Zone configuration retained in memory if power is lost

• Available in 12 and 24 volt models (EA400-12 and EA400-24)
• Simultaneous operation of all four zones
• Defrost time delay up to 120 minutes
• Easy to read large LCD display
• Eight event alarm memory with time and date
• Auxiliary output relay for local audible alarm
• Auxiliary alarm silence feature with 10 minute timer
• Each zone has offset calibration adjustment
• Temperature & humidity high/low set points
• Output relays can be configured to be initially energized or de-energized
• Tamper proof lock setting
• Snap fit mounting base with main housing for easy access
• Plug in terminal strip connectors for easier wire termination
• Zones being monitored are displayed every few seconds
• Display F°, C°, % (Humidity) or Water Drop icon
• Zone configuration retained in memory if power is lost

Wall console-type humidity monitoring device with easy to use setting dial. Applications include computer rooms, energy management systems, office areas, museums, document storage areas and greenhouses. With nylon banded sending element, this unit monitors a range of 20% to 80% RH. It requires no power to operate and can activate alarm systems, controls, and digital communication equipment through the SPDT output switch.

W-S-S is a supervised surface mount water sensor designed for use with the systems listed below. Supervised sensors will alarm if wire is severed as well as when water is detected.

Additional Surface Sensor For Waterbug 200 And 350

WaterBug WB200

WaterBug WB350

WaterBug WB800