Tools and Miscellaneous

CP-U Lighting Control Panel was developed to simplify 
the installation of PulseWorx UPB Lighting Control Systems. 
The LCP-U panel was designed to house upto ten WS1D-24, fifteen WS1D-15, or twenty WS1D-6 dimmers, controlling 
up to twenty individual circuits and delivering up to 
24,000W of power.

All of the above dimmers can each be connected to one or more remote slave switches (with one line-voltage traveler) enabling hard-wired on/off/dimming control of each circuit. All WS1D Dimmers can also control low-voltage magnetic loads, such as outdoor lighting.

The LCP can also accommodate any single, double or four gang devices. This is ideal for new construction.

The TPR-120 Three-Phase Repeater is a small electronic device that enables communication between PulseWorx™ and other devices using the Universal Powerline Bus (UPB™) method of communication on three-phase 120/208VAC Delta-Wye 60Hz power.

The Three-Phase Repeater will now bridge the communication gap between phases within multi-dwelling units, apartments, condominiums and light commercial office and restaurant facilities. Initially UPB™ communication was designed to work on a single phase powerline; the signals will not directly jump across all three phases of a 120/208V electrical system. The TPR now transfers any UPB™ multi-packet generated on a single phase and positions and repeats them properly onto all three phases of the powerline.

The TPR is simple to install and configure, just connect it to a standard 3 phase circuit breaker. The TPR is easily added to any UPB Network using UPStart Setup Software, which enables customization of the TPR's performance and the ability to run communication tests from the TPR to all devices in the network.

• Single cycle crimp and flush trim
• Easily interchangeable
• Reversible for ambidextrous operation
• Connectors lock into tool for correct positioning during crimp
• Compatible with ezEX™44 and ezEX™48 connectors
• Terminates larger cables and conductors Cat6 and Cat6A

• Single cycle crimp and flush trim
• EZ-RJ45® Die is easily interchangeable
• Reversible EZ-RJ45® Die for ambidextrous operation
• Connectors lock into tool for correct positioning during crimp
• Compatible with EZ-RJ45 connectors: EZ-RJ45 Cat5e and Cat6, Shielded Cat5e and Cat6 connectors (internal and external ground)

The EZ-Grip Puck is manufactured from a special rubberized material for flexibility and durability. Never has such a simple, inexpensive tool saved so much time and energy when working with wire and cable! The puck fits in the palm of the hand and dramatically improves your grip when pulling or pushing cable. Use the puck as a stable base for punching down wire in keystone jacks. No more marred surfaces or stab wounds!

• Improves grip dramatically when pulling fish tape through conduit.
• Provides a stable base for terminating wire in a keystone jack.
• Improves grip dramatically when pushing cable into F connectors.
• Made in the USA